Nyce 4000 Hardware Glossary - Bosch rexroth NYCe 4000 Hardware Manual

NYCe 4000 Multi-axis motion control system Hardware Sys‐
tem Manual
15

NYCe 4000 Hardware Glossary

A B
Fig. 15-1: NYCe 4000 components
Component Name
A module holder
B base plate
C system
backplane
D I/O backplane
E MCU
F drive module
G header
Tab. 15-1: Identification names of the components
NYCe 4000 Hardware Glossary
C
D
G
Type number Remarks
- -
- -
- Interconnect between MCU module
and other NYCe 4000 motion node
modules.
- Connection
NYCe 4000 drive modules and motor
and I/O headers.
NY4110, Motion Control Unit. This is not a
NY4112, "drive" but actually a unit, because it
NY4114 can be used 'stand-alone'. If an MCU
is put in a system housing, you can
communicate with it.
NY41xy, These components are not "units"
where xy = 20, because they cannot be used 'stand-
25, 30, 40, 50 alone'. If only a drive module is put in
a system housing, you cannot do
any useful work with it.
Drive module can also be I/O
module, power supply module, or
SERCOS III Master module.
- For clear
'connector' at the end of a cable is
called "plug" and the 'connector' on a
[system, I/O] backplane is called
"header".
R911337671_Edition 18 Bosch Rexroth AG
211/233
E
F
panel between
identification the