Scanning To A Computer Over A Network - Lexmark X5470 User Manual

5
Press or repeatedly until the menu item you want appears, and then press
6
Press or repeatedly until the submenu item or the setting you want appears, and then press
Note: Pressing selects a setting. An * appears next to the selected setting.
7
To go into additional submenus and settings, repeat pressing
setting you want appears, and then press
8
If needed, press repeatedly to return to the previous menus and make other setting selections.
9
Press Start Color or Start Black.
Use this
Quality*
Original Size*
Tools
* Temporary setting. For information on saving temporary and other settings, see the related topic, "Saving
Settings."

Scanning to a computer over a network

1
Make sure:
•
The printer is connected to the network through a print server, and the printer, the print server, and the
computer receiving the scan are on.
•
The printer is configured to scan over a network (Direct IP Printing).
2
Load an original document facedown into the ADF or on the scanner glass.
Note: Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine
clippings) into the ADF. Place these items on the scanner glass.
3
From the control panel, press Scan Mode.
4
Press or repeatedly until the computer to which you want to scan is highlighted.
5
If you set a PIN during network setup, enter it using the numeric keypad, and press
6
Press or repeatedly until the scan destination you want appears.
7
Press Start Color or Start Black.
.
To
Adjust the quality of a scan.
Specify the size of the original document.
•
Maintenance
–
View ink levels.
–
Clean cartridges.
–
Align cartridges.
–
Print a test page.
•
Device Setup—Customize printer setup settings.
•
Defaults—Customize printer settings.
Scanning
or repeatedly until the submenu item or the
98
.
.
.