Audi A8 2010 Workshop Manual page 11

Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
❑ Fitting location of connector
❑ Removing and installing
8 - Throttle valve module -J338-
❑ Fitting location ⇒ page 12
❑ Removing and installing
9 - Engine control unit -J623-
❑ Fitting location ⇒ page 9
❑ Removing and installing
10 - Intake air temperature sender -G42- / intake manifold pressure sender -G71-
❑ Fitting location ⇒ page 13
❑ Removing and installing
11 - Sender 1 for secondary air pressure -G609-
❑ USA version only
❑ Fitting location ⇒ page 16
12 - Activated charcoal filter solenoid valve 1 -N80-
13 - Engine speed sender -G28-
❑ Fitting location ⇒ page 15
❑ Removing and installing
14 - Knock sensor 1 -G61-
❑ Fitting location ⇒ page 11
❑ Fitting location of connector
15 - Injectors, cylinder bank 1
❑ Injector, cylinder 1 -N30-
❑ Injector, cylinder 2 -N31-
❑ Injector, cylinder 3 -N32-
❑ Removing and installing
16 - Temperature sender for engine temperature regulation -G694-
❑ Fitting location ⇒ page 12
17 - Intake manifold flap potentiometer -G336-
❑ Fitting location ⇒ page 13
18 - Hall sender -G40-
❑ Fitting location ⇒ page 13
19 - Fuel metering valve -N290-
❑ Fitting location ⇒ page 11
20 - Fuel pressure sender for low pressure -G410-
❑ Fitting location ⇒ page 11
Engine compartment (left-side)
⇒ page 10
⇒ page 42
⇒ page 25
⇒ page 48
⇒ page 25
⇒ page 56
⇒ page 10
⇒ page 30
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A8 2010 ➤
2. Injection system
7