Audi A8 2010 Workshop Manual page 14

Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
Fitting location of accelerator position sender -G79- / accelerator
position sender 2 -G185-
♦ In accelerator pedal module
Note
The accelerator position sender -G79- and accelerator position
sender 2 -G185- are integrated in the accelerator pedal module
and cannot be renewed individually.
Removing and installing ⇒ Rep. gr. 20
Fitting location of brake light switch -F-
♦ In footwell on brake pedal
Removing and installing ⇒ Rep. gr. 45
Electrical connectors at rear right of engine
1 - For injectors on cylinder bank 1
2 - For throttle valve module -J338-
3 - For knock sensor 1 -G61-
4 - For Lambda probe -G39- with Lambda probe heater -Z19-
5 - For Lambda probe after catalytic converter -G130- with
Lambda probe 1 heater after catalytic converter -Z29-
Electrical connectors at rear left of engine
1 - For Lambda probe 2 after catalytic converter -G131- with
Lambda probe 2 heater after catalytic converter -Z30-
2 - For Lambda probe 2 -G108- with Lambda probe heater 2 -
Z28-
3 - For injectors on cylinder bank 2 and for fuel pressure sender
-G247-
4 - To knock sensor 2 -G66-
10
Rep. gr.24 - Mixture preparation - injection
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.