Audi A8 2010 Workshop Manual page 17

Hide thumbs Also See for A8 2010:

Table of Contents

Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011

Fitting location of intake manifold flap potentiometer -G336-

♦ At front of intake manifold (bottom section, right-side)

Note

The fitting location of the intake manifold flap potentiometer 2 -

G512- is symmetrically reversed.

Fitting location of intake air temperature sender -G42- / intake

manifold pressure sender -G71-

♦ At rear of supercharger with charge air cooler

1 -

Electrical connector for intake air temperature sender -

G42- / intake manifold pressure sender -G71-

Fitting location of charge pressure sender -G31- / intake manifold

temperature sender -G72-

♦ At right side of supercharger with charge air cooler

1 -

Electrical connector for charge pressure sender -G31- / in‐

take manifold temperature sender -G72-

Note

Intake manifold temperature sender 2 -G430- / charge pressure

sender 2 -G447- are located symmetrically reversed.

Removing and installing ⇒ Rep. gr. 21

Fitting location of Hall sender and camshaft control valve on cyl‐

inder bank 1 (right-side)

1 -

Camshaft control valve 1 -N205-

2 -

Hall sender -G40-

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not

permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability

with respect to the correctness of information in this document. Copyright by AUDI AG.

Audi A8 2010 ➤

2. Injection system

Table of Contents