Removing And Installing Ignition Coils - Audi A8 2010 Workshop Manual

Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
11 - Engine speed sender -G28-
❑ Removing and installing
12 - O-ring
❑ Renew
13 - Hall sender 2 -G163-
❑ Removing and installing
14 - Bolt
❑ 9 Nm
2.3

Removing and installing ignition coils

Special tools and workshop equipment required
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
♦ Puller -T40039-
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Remove engine cover panels
– Move fuel line -1- and line -2- from activated charcoal filter
clear on air cleaner housing and air pipe.
– Detach vacuum hose -3- from connection on air pipe.
– Release hose clips -arrows- and remove air pipe.
– Remove bolts -arrows- from cylinder bank 1 and unplug elec‐
trical connectors at ignition coils.
– Move electrical wiring harness down slightly.
Note
Disregard -items 1, 2-.
⇒ page 56
⇒ page 55
⇒ page 18 .
Audi A8 2010 ➤
2. Servicing ignition system
53