Audi A8 2010 Workshop Manual page 16

Hide thumbs Also See for A8 2010:

Table of Contents

Audi A8 2010 ➤

Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011

Fitting location of temperature sender for engine temperature

regulation -G694-

♦ -Item 1- below intake manifold (bottom section) on cylinder

bank 1 (right-side)

Removing and installing ⇒ Rep. gr. 19

Fitting locations below intake manifold (bottom section) on cylin‐

der bank 2 (left-side)

1 -

Injector, cylinder 6 -N84-

2 -

Injector, cylinder 5 -N83-

3 -

Injector, cylinder 4 -N33-

4 -

Fuel pressure sender -G247-

5 -

Knock sensor 2 -G66-

Fitting location of throttle valve module -J338-

♦ At rear of supercharger

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not

Fitting location of regulating flap control unit -J808-

3 - Regulating flap control unit -J808-

♦ At rear of supercharger

Rep. gr.24 - Mixture preparation - injection

permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability

with respect to the correctness of information in this document. Copyright by AUDI AG.

Table of Contents