Table of Contents
Advertisement
Operating the System
Detector, Wallstand
4.10.1.3 Method to Remove 14x17 inches Detector, Wallstand
The method of removing the detector from the detector tray is as follows.
1. To remove the detector, in step 2 of "Method to set the detector", unlock the connector by
pulling the latch of the detector tray in the direction of the arrow.
Note!
• Depending on left or right operated wallstand, the location of the detector tray and position
of button and latches is different.
OMNERA 500A
Fig. 4-41 Unlocking detector latch
1000-095-071-EN Rev. 2.1
Page 122
Operator´s Manual
Advertisement
Table of Contents
