Table of Contents
Advertisement
15.
IMPORTANT:
At this point all the displays should be displaying stable running video from the selected
sources. If you do not have them displaying properly, than network switch is configured incorrectly.
16. Navigate to Maintenance -> File Management -> Configuration File Copy. Select radio buttons as shown
below, click Apply. This will save current configuration and will apply this configuration every time switch is
powered up.
17.
IMPORTANT:
Now you can connect back you DHCP equipment (routers, servers and so on).
18. Power down Linksys network switch and power it up back again. Wait for the whole system to start and until
you can see video on your displays.
Back to top
62 |
P a g e
Advertisement
Table of Contents
