Key Digital KD-IP1022ENC Manual page 23

18. Click Done.
19. Power down Cisco network switch and power it up back again. Wait approx 5 minutes to reboot, and
connection your Encoders, Decoders, and DHCP equipment (routers, servers and so on). After approx 2
minutes of bootup for the AV over IP equipment, you should see image on your displays
20. Log in to your Cisco network switch again and make sure that IGMP settings are intact:
21. Rescan your components with Key Digital Management Software and make sure HDMI video switch is
functional.
22. At this point your Linksys network switch is set and ready to use.
23. Connect your encoders, decoders, allow approx 3 mins for bootup, and perform a network scan using KD
Management Software.
Back to top
23 | P a g e