Table of Contents
Advertisement
IGMP Setup Guide: TP-Link TL-SG2428P (Single use only available, not stackable)
1. Power-up the TP-Link network switch.
2.
IMPORTANT:
Disconnect all the DHCP devices like routers or servers from the TP-Link network switch.
3. (If you want factory reset of the switch) Locate a pinhole "RESET" button at the front center panel of your
TP-Link network switch. Using a paper clip press and hold a reset button for more than 5 seconds and then
release. The factory reset process generally takes 5 minutes to complete
4. Connect your PC to the TP-Link network switch directly using a network cable.
5. If you have not done yet, configure your PC's IP address to the same range as the switch.
(default subnet of the switch - 192.168.0.xxx).
6. Enter the switch's IP address in your browser and press ENTER (default IP address - 192.168.0.1).
7. Enter username and password (default "admin" for both). Then click Log In. If this is the first time logging in,
Back to top
4K Systems (KD-IP822, KD-IP922, KD-IP1022)
there will be a prompt to create a new password.
111 |
P a g e
Advertisement
Table of Contents
