Key Digital KD-IP1022ENC Manual page 118

19. Save the current configuration.
Click "Save" button on top right corner. Click Yes.
This will save current configuration and will apply this configuration every time switch is powered up.
20.
To double-check the updated configuration, reboot the network switch and confirm the configuration.
After rebooting the switch, log in to your TP-Link network switch again and make sure that IGMP settings
are intact.
21.
At this point your Linksys network switch is set and ready to use
22. Connect your encoders, decoders, allow approx 3 mins for bootup, and perform a network scan using KD
Management Software.
Back to top
.
118 | P a g e