Table of Contents
Advertisement
1.
IMPORTANT:
Disconnect all the DHCP devices like routers, servers from the Araknis network switch.
2. Locate a pinhole "RESET" button at the front panel left bottom corner of your Araknis network switch. Using
a paper clip press and hold a reset button for more than 10 seconds and then release. Wait while the device
is restarted and ready to use (about 5min).
3.
IMPORTANT:
At this point all the displays should be displaying distorted randomly flashing video images.
4. Connect your PC to the Araknis network switch directly using a network cable.
5. If you have not done yet, configure your PC's IP address to the same range as the switch (default
192.168.20.xxx).
6. Enter the switch's IP address (default is 192.168.20.254) in your browser and press ENTER.
7. Enter user name and password (default is "araknis" for both). Then click Log In.
8. Navigate to Settings -> System. Under IP Address Settings elect Static. Change an IP address to
192.168.1.251, Subnet Mask to 255.255.255.0, Default Gateway to 192.168.1.1 (in this case), and at the
bottom click Apply. If you are setting up multiple network switches it is recommended to set first one to
192.168.1.251, second to 192.168.1.252, and so on, and each switch must be set individually same way as
described below.
Back to top
IGMP Setup Guide: Araknis
4K Systems (KD-IP822/922/1022)
12 |
P a g e
Advertisement
Table of Contents
