Table of Contents
Advertisement
1.
IMPORTANT:
Disconnect all the DHCP devices like routers, servers from the Linksys network switch.
2. Locate a pinhole "RESET" button at the front panel left bottom corner of your Linksys network switch. Using
a paper clip press and hold a reset button for more than 10 seconds and then release. Wait while the device
is restarted and ready to use (about 5min).
3.
IMPORTANT:
Make sure the blue "SYSTEM"LED next to the pinhole "RESET" button is flashing.
4.
IMPORTANT:
At this point all the displays should be displaying distorted randomly flashing video images.
5. Connect your PC to the Linksys network switch directly using a network cable.
6. If you have not done yet, configure your PC's IP address to the same range as the switch (default
192.168.1.xxx).
7. Enter the switch's IP address in your browser and press ENTER (check the user manual for a default IP
address - it is usually 192.168.1.251).
8. Enter user name and password (check the user manual for a default user name and password; it is usually
"admin" for both). Then click Log In.
9. Navigate to Configuration -> IP Interface -> IPv4-> IPv4 Interface. Select Static IP Address. IP address can be
changed by the administrator depending on the network configuration. If you are using multiple network
switches it is recommended to set first one to 192.168.1.251, second to 192.168.1.252, and so on (we will
leave the IP address unchanged). Set Subnet Mask to 255.255.255.0, set User Defined Default Gateway to
192.168.1.1 (in this case), make sure that Management VLAN is set to"1" and click Apply. If you changed an
Back to top
IGMP Setup Guide: Linksys
1080p Systems (KD-IP1080, KD-IP120)
58 |
P a g e
Advertisement
Table of Contents
