Hdmi extender, booster & buffer of edid/hdcp/ tmds/3d/arc/ ultra hd/4k with edid control, hot plug control & built-in audio de-embedder of coaxial, analog l/r & digital audio (6 pages)
Hdbaset/hdmi via single cat5e/6 (tx+rx set) extenders, support ultra hd/4k, edid control, hot plug control, full buffer system, ir sensor, up/down ir & rs-232
power over hdbaset/hdmi via single cat5e/6 (tx+rx set) extenders, support ultra hd/4k, edid con (12 pages)
Hdbaset/hdmi via single cat5e/6 (tx + rx set) extenders,
support ultra hd/4k, edid control, hot plug control,
long range mode, full buffer system, hdmi pass-through, ethernet, ir sensor, up/down ir & rs-232 (12 pages)
, led by digital video pioneer Mike Tsinberg, ® develops and manufactures high quality, cutting-edge technology solutions for virtually all applications where high-end video and control are important. Key Digital ® is at the forefront of the video industry for Home Theater Retailers, Custom Installers, System Integrators, Broadcasters, Manufacturers, and Consumers.
An Ethernet switch with Internet Group Management Protocol (IGMP) is recommended to maximize the performance of the system. Please check the Key Digital Website for an 10. Refer to the KD-IP120 Tool section for more information on the below.
Active link (Blue LED) illuminated when active HDMI/DVI Signal is present » Does not support CEC » B. Output Connections HDMI Pass-through › Compatible with DVI1.0/HDMI1.3b/HDCP1.x » Video Resolution supports up to 1080p@60 (2.25Gbps) » Audio format support up to 2ch PCM at 44.1/48kHz »...
Page 5
KD-IP120 Rx Unit - Back Panel Operation KD-IP120 Rx Unit - Front Panel Operation A. LED Light A. Input Connections IP Link › Ethernet › Active link (Blue LED) illuminated when Tx Unit is connected to the Rx Unit via IP »...
KD-IP120 Tool The Key Digital KD-IP120 Tool software is required for setting up the KD-IP120. For unit setup instructions, please refer to the “Quick Setup Guide” section. Creating and saving a new system file: To create a new system file after configuring all Tx and Rx units, first, click “Network...
Web Interface The KD-IP120 Web Interface provides basic configuration settings for operation. To use the Web Interface, connect a PC to the Smart Managed Switch and ensure that the IP address is on the same subnet as the KD-IP120 unit. First method of connection to a KD-IP120 unit may be done by using a crossover network cable directly from your computer.
For KD-IP120 Tx and Rx For TCP/IP control, make sure the TCP/IP client is on the same network as the KD- MC1000 and the KD-IP120. The port for control is telnet (23). Network Setup is where the IP Addresss, Subnet Mask, and Router IP Address may be ›...
Key Digital ® Warranty and risk damage to your unit and associated equipment. ® should provide years of trouble-free operation. They are backed by a Key Digital Limited 10 Year Product Warranty Policy. http://www.keydigital.com/warranty.htm...