Connecting The Power And Host Pc - ICP DAS USA ZT-2510 Series User Manual

D.
"RF Power" is the wireless transmit power.
Hex Code
※ The parameter adjustment purely personal behavior, ICP DAS can not
guarantee to pass CE/FCC certification if adjusting this parameter, nor
assume any liability because of the adjustment parameters derived from
the RF Power.

4.2 Connecting the Power and Host PC

1.
Connect the interface USB port for doing configuration.
2.
Connect the DC.GND and DC.+Vs pins with 10 to 30V power supply.
SAFETY INSTRUCTION NOTES
Before connecting the power source to the power input pins, ensure that
both the installation of the unit in the completed system, and the DC
power source (SELV, Limited Power Source) that is intended to be
connected to the power input pins (DC.+Vs / DC.GND) comply with the
requirements of EN 60950-1.
ICP DAS, ZT-2510 User Manual, Version 2.0
Copyright @ 2012 by ICP DAS Co., Ltd. All Rights Reserved.
0x0F
0x08
0x00
F.G.
GND
+VS
Description
Typical Maximum
Fit the CE/FCC certification
Typical Minimum
CA-0915
Windows Based PC
DC.GND
DC.+Vs
Page 11