Suzuki UG110 2021 Service Manual page 51

3-22 ENGINE
• Remove the bearing using the special tool.
2 09941-50111: Bearing remover
5
Replace the removed bearing with a new one.
• Remove the oil seals 1 and O-rings 2.
5
Replace the removed oil seals and O-rings with new ones.
CLUTCH SHOES
Inspect the clutch shoes for chips, cracks, uneven wear and burn-
ing. Check the thickness of the shoes using vernier calipers. If
any damages are found or if the thickness is less than the service
limit, replace the clutch shoes as a set.
2 09900-20101: Vernier calipers
4 Clutch shoe thickness
Service Limit: 4.0 mm
Inspect the clutch springs for stretched or broken coils. If any
damages are found, replace the clutch springs as a set.
5
Replace the clutch shoes and clutch springs as a set.
Inspect the clutch housing surface for scrolling, cracks, or un-
even wear and measure the inside diameter of the clutch hous-
ing with inside calipers. Measure the diameter at several points to
check for out-of-round and wear. If any damages are found or if
the inside diameter exceeds the service limit, replace the clutch
housing with a new one.
4 Clutch housing I.D.
Service Limit: 110.50 mm