Suzuki UG110 2021 Service Manual page 63

3-34 ENGINE
• Install the rear axle shaft oil seal into the gear box cover, slowly,
using the special tool.
2 09913-70210: Bearing installer set ( φ φ φ φ φ 40 mm)
DRIVE SHAFT OIL SEAL
• Remove the drive shaft oil seal 2 from the left crankcase using
the special tool.
2 09913-50121: Oil seal remover
5
Replace the removed oil seal with a new one.
• Install the drive shaft oil seal into the left crankcase, slowly,
using the special tool.
2 09913-70210: Bearing installer set ( φ φ φ φ φ 30 mm)
CRANKSHAFT OIL SEALS
• Remove the left crankshaft oil seals from the left crankcase,
using the special tool.
2 09913-50121: Oil seal remover
5
Replace the removed oil seals with new ones.
• Remove the right crankcase oil seal from the right crankcase,
using the special tool.
2 09913-50121: Oil seal remover
5
Replace the removed oil seal with a new one.