Table of Contents
Advertisement
CHK
ADJ
Electrical / Jet pump unit
2
A A
5
1
1
3
A A
4
NOTICE
Connect the positive battery cable 4 to the
battery terminal first.
TIP
• Make sure that the battery breather hose 3
• Apply water resistant grease to the terminals
Jet pump unit
Jet pump unit check
Make sure to remove the battery before
checking the jet pump unit.
a
3-21
4. Install:
• Battery 1
• Bands 2
• Battery breather hose 3
• Positive battery cable 4
• Negative battery cable 5
is properly connected and is not obstructed.
to minimize corrosion.
WARNING
1. Check:
• Impeller 1
Damage → Replace the impeller.
2. Measure:
• Impeller-to-housing clearance a
Out of specification → Measure the
impeller housing inside diameter.
Refer to "Impeller duct, impeller housing
and nozzle removal" in Chapter 6.
Impeller-to-housing clearance a:
0.35–0.45 mm (0.014–0.018 in)
E
1
2
4
5
6
7
8
9
Advertisement
Chapters
Table of Contents
