Table of Contents
Advertisement
–
+
ELEC
Control system
3
É
È
2
1
a
7-36
Steering sensor
1. Check:
• Steering sensor operation
Does not operate → Measure the steer-
ing sensor input voltage.
Checking steps:
1. Connect a computer to the watercraft to
use the YDIS.
2. Turn the handlebar all the way to the left or
right.
3. Install a plastic tie 1 loosely around the
center a of the handlebar grip as shown.
4. Hook a spring gauge 2 onto the plastic tie
1.
5. Push the unlock button.
6. Hold the spring gauge 2 at a 90° angle
from the handlebar grip, and then pull the
spring gauge in direction È as shown with
a force of 10 kgf (22 lb).
TIP
At this time, the button 3 in the steering sen-
sor will be pushed in direction É.
7. Check that the following is displayed in the
"Engine monitor" window of the YDIS.
Steering sensor operation:
Handlebar
Not pulled
Pulled
8. Use the same procedure to check that the
steering sensor operates correctly when
the handlebar is turned to both the left and
right.
E
1
2
3
4
5
YDIS display
6
OFF
ON
7
8
9
Advertisement
Chapters
Table of Contents
