Dual Analog Meter Unit - Yamaha WaveRunner FZR-GX1800 Service Manual

GEN
INFO

Dual analog meter unit

The FZR and FZS feature a newly designed dual analog meter unit.
1 2
Item
1 "Hour Volt" button
2 Speedometer
3 Information display
4 Tachometer
5 "WARNING" indicator light
6 "L-MODE" indicator light
7 "UNLOCK" indicator light
Initial operation
When the unlock button on the remote control transmitter is pushed, the buzzer sounds 2 or 3 times,
the speedometer 2 and tachometer 4 make 1 sweep, the information display 3, the "WARNING"
indicator light 5, and the "L-MODE" indicator light 6 come on for 2 seconds, and then the unit
starts to operate normally.
Hour meter/voltmeter
*1
Push the "Hour Volt" button 1 for at least 1 second to switch the display to the hour meter or to
the voltmeter.
Feature and benefit
3
7 6
Switches the display to the hour meter or to the voltmeter.
Shows the watercraft speed against water.
The large inner numbers on the meter show the watercraft
speed in miles per hour (MPH) and the small outer numbers
show the speed in kilometers per hour (km/h).
Shows watercraft operating conditions.
a Fuel level meter
b Fuel indicator
c Engine overheat warning indicator
d Check engine warning indicator
e Oil pressure warning indicator
f Hour meter/voltmeter
Shows the engine speed (RPM).
Flashes or comes on, together with each warning indicator in
the information display, when a malfunction has occurred.
Comes on when the L-MODE (low-RPM mode) is selected.
Comes on when the unlock mode of the Yamaha Security
System is selected.
*1
The hour meter shows the hours of engine operation that have elapsed
since the watercraft was new.
The voltmeter shows the battery voltage. When the battery voltage is
normal, the voltmeter displays approximately 12 volts. If the battery
voltage has dropped significantly, "LO" is displayed on the voltmeter. If
the battery voltage has risen significantly, "HI" is displayed.
4
5
Functions
1-23
a b c d
E
e
2
f
3
4
5
6
7
8
9