Yamaha WaveRunner FZR-GX1800 Service Manual page 196

POWR
2 1
3
Generator cover and flywheel magneto
2
2. Install:
• Special nut 1
• Transfer shaft 2
Installation steps:
1. Remove any grease from the special nut
1
1 and the inner surface of the transfer
shaft 2, making sure that the threads of
the nut and shaft are clean and dry.
2. Install the special nut 1 into the transfer
shaft 2 until it can no longer be turned.
NOTICE
• Do not reuse the special nut 1 and trans-
fer shaft 2, always replace them with a
new transfer shaft assembly.
• Do not scratch the ends of the special nut
1 or the end of the transfer shaft 2 that
makes contact with the flywheel magneto.
• Insert the hexagon bit socket 3 into the
threaded end of the transfer shaft 2.
• If any grease remains on the special nut
1 and transfer shaft 2, or if the special
nut 1 is not installed completely, the
transfer shaft 2 cannot be installed cor-
rectly.
5-89
E
1
2
3
4
6
7
8
9