Shift Cable Check And Adjustment - Yamaha WaveRunner FZR-GX1800 Service Manual

CHK
ADJ
Control system
2
1
1
2
5
4
3
1
LT LT
572
1
3
4
a
2
b
3-8

Shift cable check and adjustment

1. Check:
• Reverse gate position
Incorrect → Adjust the shift cable joint.
Checking steps:
1. Set the shift lever to the reverse position.
2. Check that the reverse gate 1 contacts
the stopper 2.
2. Adjust:
• Shift cable joint (jet pump end)
Adjustment steps:
1. Set the shift lever to the reverse position.
2. Loosen the locknut 1.
3. Disconnect the shift cable joint 2 from the
ball joint 3.
4. Situate the reverse gate 4 to the stopper
5.
5. Turn the shift cable joint 2 in or out until
the specified distance a between the cen-
ter of the joint and the center of the ball
joint 3 is obtained.
WARNING
The shift cable joint must be screwed in
more than 8 mm (0.31 in) b.
Turn in Distance is decreased.
Turn out Distance is increased.
Distance a:
7.0 mm (0.28 in)
E
1
2
3
4
5
6
7
8
9