Adjusting The Jet Thrust Nozzle Angle - Yamaha WaveRunner SuperJet 2020 Owner's/Operator's Manual

Maintenance
(2) Remove the four screws, and then re-
move the handlebar cover.
1
1 Handlebar cover
(3) Turn the handlebars so that the left han-
dlebar grip is facing down.
(4) Loosen the locknut.
(5) Tighten or loosen the adjusting nut until
the desired amount of friction is ob-
tained.
1 Adjusting nut
2 Locknut
(6) While holding the adjusting nut with a
wrench, tighten the locknut to the speci-
fied torque.
Tightening torque:
Locknut:
28 N·m (2.8 kgf·m, 21 lb·ft)
(7) Securely install the handlebar cover and
four screws in their original positions.
61
(8) While holding the steering pole, move
the lock pin to the stowed position, and
then lower the steering pole.
EJU3128A

Adjusting the jet thrust nozzle angle

The angle of the jet thrust nozzle can be ad-
justed to two settings to suit operator prefer-
ence.
To adjust the jet thrust nozzle angle:
(1) Remove the two bolts, and then remove
the steering pole cover.
1 Steering pole cover
(2) Pull back the outer sleeve of the steering
cable joint, and then disconnect the joint
from the steering cable pivot bolt.
1 Steering cable joint