Steering Cable Installation (Steering Master End) - Yamaha WaveRunner FZR-GX1800 Service Manual

HULL
HOOD
Remote control cables and speed sensor lead
b b
5
1
a
2
3
c
4
8-34
Steering cable installation (steering
master end)
WARNING
If a cable becomes damaged, replace it.
Never attempt to repair a damaged cable.
1. Install:
• Steering cable
Installation steps:
1. Insert the projection a on the steering
cable completely into the indentation b in
the cable stopper assembly.
2. If the projection a on the steering cable is
not aligned properly to fit into the indenta-
tion, rotate the drum nut 1 counterclock-
wise a maximum of 90° for proper
alignment.
NOTICE
Do not attempt to twist the steering cable to
align it. Make sure to turn the drum nut 1
to install the steering cable.
3. Slightly pull out the clamp plate 2 on the
cable stopper assembly, and then rotate it
clockwise to lock it in place securely.
4. Rotate the clamp plate 3 on the cable
stopper assembly counterclockwise, mak-
ing sure to fit the hole in the plate onto the
projection c on the other clamp plate 2.
5. Connect the steering cable joint 4 to the
ball joint 5.
E
1
2
3
4
5
6
7
8
9