Table of Contents
Advertisement
HULL
HOOD
Handlebar
1
2
1
a
1
3. Install:
• Throttle cable
• Right handlebar grip
Installation steps:
1. Install the throttle cable end into the throt-
tle lever.
2. Fit the seal 1 into the groove in the
bracket.
3. Pull the throttle cable 2 in the direction of
the arrow shown, and then fit the end of
the seal 1 around the inner cable.
4. Adjust the throttle lever free play.
Refer to "Throttle lever free play check and
adjustment" in Chapter 3.
NOTICE
Make sure to adjust the free play with the
handlebar bracket in the lowest position.
Otherwise, the specified free play with the
handlebar bracket in the highest position
cannot be obtained.
Throttle lever free play a:
2.0–5.0 mm (0.08–0.20 in)
5. Apply adhesive to the handlebar and the
inner surface of the handlebar grip.
6. Install the right handlebar grip.
Handlebar cover installation
1. Install:
• Lower handlebar cover
• Steering pad 1
• Upper handlebar cover
TIP
Fit the throttle cable into the groove in the
steering pad.
8-9
E
1
2
3
4
5
6
7
9
Advertisement
Chapters
Table of Contents
