Adjusting The Select Lever Control Cable And Shift Rod - Yamaha YFM45FXV Supplementary Service Manual

ADJUSTING THE SELECT LEVER CONTROL CABLE
AND SHIFT ROD
ADJUSTING THE SELECT LEVER
CONTROL CABLE AND SHIFT ROD
1 NEUTRAL
2 FORWARD
3 REVERSE
4 PARK
5 Control cable
6 Select lever shift rod
WARNING
Before moving the select lever, bring the
vehicle to a complete stop and return the
throttle lever to its closed position. Other-
wise the transmission may be damaged.
1. Adjust:
• brake pedal height
Refer to "ADJUSTING THE REAR BRAKE".
2. Adjust:
• select lever control cable
• select lever shift rod
M MMM M MMM M M MMM
Control cable:
a. Remove the rear brake master cylinder
cover 1.
b. Make sure the select lever is in NEUTRAL.
c. Adjust the control cable so there is zero free
play in the cable. When the adjustment is
correct, slack in the return spring 2 will be
taken up.
NOTE:
In some cases it will be necessary to further
adjust the cable with the locknuts 3 arrange-
ment that holds the cable to its mount.
d. When the brake begins to work "a = 20 ~
30 mm (0.8 ~ 1.2 in)", verify that the select
lever can be shifted to REVERSE from
NEUTRAL, to PARK from REVERSE, to
REVERSE from PARK, and to NEUTRAL
from REVERSE.
e. Before the brake begins to work "a = 0 ~
20 mm (0 ~ 0.8 in)", verify that the select
lever cannot be shifted to REVERSE from
NEUTRAL, to PARK from REVERSE, to
REVERSE from PARK, and to NEUTRAL
from REVERSE.
– 34 –
CHK
ADJ
M M MMM M M MMM M M MMM M MMM