Power Connection; Connecting The Power Cable - Burmester 218 Operation Manual

POWER CONNECTION

DANGER! POWER CONNECTION AND
PROTECTIVE EARTH CONDUCTOR
Use the -wire power cable supplied with the device to connect it
3
to the power supply. The protective earth contact must never be disabled.
The voltage is set at the factory to the national standard for the country in
which you purchased your Burmester device. If your device is to be
operated with a different voltage than the one set at the factory, please
contact your Burmester dealer. They know which modifications have to be
made to the device. Before putting the device into operation, check to see
if the power voltage specified on the back panel of the device matches the
mains voltage in your household. If you are uncertain of the mains voltage
at your installation site, please make sure you check with your authorised
Burmester dealer prior to installation.
Route the power cable in such a way that it cannot be damaged.
Do not use the power cable if it has been damaged.

CONNECTING THE POWER CABLE

1. Before connecting the power cable, first establish all other connections to the device.
Before connecting the device, make sure that the power switch (
2.
device is in OFF position.
3. Plug the enclosed power cable into the power jack (
4. Plug the power plug into a nearby socket.
Do not switch on the device before all connections have been established and
5.
checked. Only switch on the power amplifier if you are sure that your preamplifier
is set to a low volume.
2 1 8 P O W E R A M P L I F I E R
) on the back of the
6
13 ) on the back of the 218 .
2 5 | 4 6