Table of Contents
Advertisement
OPERATING THE DEVICE
AC input
Make sure the mains switch (9) is set to OFF. Connect the power cable to the AC input (8) and
plug the mains plug into the mains socket.
Mains switch
The mains switch (9) on the rear panel of the device disconnects the 911 from the mains power
supply.
When the switch is in the OFF position, the device is completely cut off from the power supply and
the LEDs on the front panel will all be off. When the switch is in the ON position, the device is in
stand-by mode and the STAND BY LED (1) on the front will be lit up.
POWER button
The POWER button (2) on the front panel is used to switch the 911 from stand-by into operational
mode, or back into stand-by. When the device is in operational mode, the STAND-BY LED (1) and
the POWER LED (3) will light up. When the device is in stand-by mode, only the STAND-BY LED
(1) will be lit up. When the 911 is switched into operational mode, the monitoring circuitry will check
all its functions. Because of this, it always takes a few seconds before the speaker outputs come on.
CONNECTION OPTIONS
STEREO mode
For STEREO mode, the 911 must be connected as follows:
(See STEREO wiring diagram)
(4)
(5)
(6)
(12)
(10)
(11)
MONO mode
For MONO mode, the 911 must be connected as follows:
(See MONO mode wiring diagram):
(4)
(5)
(6)
(12)
(10)
(11)
BI-AMP mode
For BI-AMPING mode, the 911 must be connected as follows:
(See wiring diagram for BI-AMPING mode):
(4)
(6)
(5)
(12)
(10)
(11)
If you are not sure whether you have connected your 911 correctly for the desired operating
mode, please contact your Burmester dealer.
Input, right channel
Speaker output, positive, right channel (red binding post)
Speaker output, negative, right channel
Input, left channel
Speaker output, positive, left channel (blue binding post)
Speaker output, negative, left channel
MONO ADAPTER, red side
Speaker output, positive (red binding post)
Must not be connected
MONO ADAPTER, blue side
Speaker output, negative (blue binding post)
Must not be connected
BI-AMP ADAPTER, red side
Speaker output, positive, woofer
Speaker output, negative, woofer
BI-AMP ADAPTER, blue side
Speaker output, positive, tweeter/mid-range driver
Speaker output, negative, tweeter/mid-range driver
7
Advertisement
Table of Contents
