Testing An Resetting; Sending Test Reports; What You Should Do If An Alarm Is Activated (Resetting); Reset With Sms To Octalarm-Ip (Only With Gsm Model) - Adesys Octalarm-IP User Manual

Adesys B.V. | Wateringen
8.

Testing an resetting

8.1

Sending test reports

Test reports can be sent as soon as the alarm has been set up to check if the alarms are
working correctly. Alarm delays that have been set may be generated when sending test
reports. Proceed as follows:
• Press Test and use the cursor key to select the function that needs to be tested;
Make your selection:
•
10. Alarm inputs;
•
• 20. Local alarms;
30. Audio;
•
40. Extensive battery test;
•
Function key F3 (select or ok) will start the test message.
•
8.2

What you should do if an alarm is activated (resetting)

Once the alarm dialler is fully functional, the following types of alarm can be given
depending on the settings:
audio signal from internal or external buzzer;
•
external flashing light;
•
voice message on a (GSM-)telephone. Pressing 8 on the keypad of your phone will
•
restart the last played voice message;
a SMS message on a mobile telephone.
•
A similar alarm report has to be reset. Resetting can be carried out on the alarm dialler
after entering a user code or, remotely with a telephone. Resetting via the telephone can
be carried out during the report itself.
The 4-figure reset codes are set in the alarm dialler. These are personal codes so the
person carrying out the reset is registered. These codes are the equivalent of the alarm's
log in codes and are in menu 03 Telephone Book.
8.3

Reset with SMS to Octalarm-IP (only with GSM model)

When an SMS is sent due to an active alarm and the call back is being waited for, an SMS
can be sent back to the alarm dialler to confirm the message. The alarm SMS contains a
code such as "*123". Sending this code via SMS to the alarm dialler's mobile number will
confirm the message. The same can be achieved by bouncing (sending back) the
incoming SMS message to the alarm dialler.
8.4

Requesting alarm status via SMS (only with GSM model)

If an SMS with the text "status" is sent to the GSM Octalarm-IP model, an SMS will be sent
back that offers a listing all active alarms.
Page 38 | Back to contents User manual Octalarm-IP | version 11-2021