Adesys Octalarm-IP User Manual page 18

7 Info key
The Info key gives access to the alarm
dialler's basic data. Among other things
you will find the dialler's identification data
such as the serial number, the software
version and the IP number. The last is
particularly important when you want to
program the alarm dialler from a
computer. You can also use the IP number
to check if the alarm dialler has an
internet connection. If no IP number is
displayed you will not be able to access
the alarm dialler via the ethernet. You can
also access the logbook from this page
where you will find an overview of the
alarm report that have been made.
8 Alarm key
The Alarm key is used to activate and
deactivate inputs, turn off alarm
forwarding temporarily or permanently,
turn local alarms on or off and to indicate
whether or not an alarm report should be
made when there is a malfunction in the
mains voltage.
9 Alarm forwarding and buzzer
These two LEDs indicate if the forwarding
for the alarms and the alarm buzzer are
switched on.
10 System malfunctions
These two LEDs indicate if reports of the
mains voltage failure and system
malfunctions that arise are being
forwarded.
11 Input status
User manual Octalarm-IP | version 11-2021
Depending on which type of alarm dialler
you have there will be two rows with 1, 2,
4, 8 or 12 LEDs. The row of red LEDs on
the left give the status of the input in
question. The LED is off when it is idle. If
the status changes the LED will flash for
the delay time that has been set. If the
input is active the red LED will stay on. The
green LEDs in the row on the right
indicates if status changes to the input in
question are being forwarded. When the
LED in question is out, nothing is being
forwarded, while the red LED in the row
on the left can still indicate that there is a
change to the input status.
12 Microphone
Models from the Octalarm A-range have a
microphone behind the grill on the left-
hand side of the front panel for recording
text when necessary for giving an alarm or
for the voice response system. Models
from the B-range do not allow recording
messages.
13 Display
All information that is required for
operating and programming the Octalarm-
IP appears on the central display. The
alarm dialler can be set more comfortably
and with a better understanding if this is
done via a computer that is connected to
the Octalarm-IP via the ethernet. No extra
software is needed to do this. Use can use
a standard web browser such as Microsoft
Internet Explorer® or Mozilla Firefox® for
this..
Back to contents | Page 17
Adesys B.V. | Wateringen