Checking Device Health Status; Device Basic Configurations - Dahua DHI-ARA3000H-FW2 User Manual

health status of devices, remotely configuring devices, and fixing errors.

4.6.1 Checking Device Health Status

You can check the online and offline status of devices in real time, and check the health status of
devices one at a time or in batches. This section uses checking in batches as an example.
The configurations for these can be found in Site mode and Device mode. The operations for these
two modes are similar. This section uses configurations in Device mode as an example.
Step 1 On the Home screen, tap
Step 2 Tap
Step 3 Tap
Step 4 Select devices you want to check, and then tap X devices selected. Start Health Check.
To select all devices, tap Select all.
Step 5 View checking results, and then tap OK.
Offline devices cannot be checked.

4.6.2 Device Basic Configurations

After adding devices, including the alarm hub and accessories, you can view and edit general
information of the device.
Step 1 On the Home screen, tap
Step 2 Tap
Step 3 In the device list, select the device as needed.
Step 4 On hub screen, tap
Parameter
Device Configuration
Hub Status
Hub Setting
Time Zone
Network Configuration
, and then it goes to Sites screen.
on the upper-left corner to switch to Device mode.
.
, and then it goes to Sites screen.
on the upper-left corner to switch to Device mode.
to view and edit general information on the device.
Table 4-1 Parameter description
Description
● View device name, type, and SN.
● Edit device name, and then tap Save to save configuration.
For details, see "4.6.2.2 Configuring the Hub".
For details, see "4.6.2.1 Viewing Status".
Tap Time Zone to select your time zone, and enable DST (daylight
saving time) if necessary.
● Time Zone: Select the time zone in which the hub operates.
● DST: Select date or week, and then select start time and end
time.
Tap Network Configuration to view your present network
information.
24
User's Manual