Table of Contents
Advertisement
12 ETS Installation and Operation Manual
The installation process for ETS consists of the following basic steps:
1. Initial installation (see "Design Considerations" on page 12).
2. Installing the ETS assembly (see page 16).
3. Connecting the ETS assembly power wiring (page 18).
4. Wiring the ETV Platinum Plus (see page 41).
5. Starting up the ETS (page 22).
Supplied Materials
The following materials are supplied with the control module:
• Installation and Operation Manual (p/n 059326‐00)
• Warranty Card (p/n 059115‐00)
Required Materials (Not Supplied)
The following materials/tools are required for installation, but are not supplied:
• General tool kit (screwdrivers, wire strippers, power drill, etc.)
• 14 AWG cable (used for incoming 120Vac power)
• 18 AWG cable (Heat‐Timer p/n 703001‐01 or equivalent #18/2 cable) for actuator wiring
• Electrical conduit
• Piping and fitting material
Design Considerations
When installing the system, certain design considerations must be taken into account. These include:
• ETS Assembly Handling Guidelines (see page 12)
• Selecting a Location for the ETS Assembly (see page 13)
• General Electrical Guidelines (see page 13)
• General Piping Guidelines (see page 14)
• Recirculation Pump Sizing (see page 15)
ETS Assembly Handling Guidelines
When transporting and handling the ETS assembly, observe the following guidelines:
• It is recommended to remove the jacket panel to avoid damaging the panel.
• The ETS‐15, ETS‐20, and ETS‐25 can be hand‐carted from the rear of the frame. DO NOT hand‐cart the
assembly from the front or sides of the frame.
• The ETS‐30 and ETS‐40 can be hand‐carted from the left side of the frame only.
• Do not use the control panel or any of the piping as a lift handle or damage can occur.
059326‐00 Rev D
Installation Instructions
Heat‐Timer Corp.
Advertisement
Table of Contents
