Table of Contents
Advertisement
16 ETS Installation and Operation Manual
Installing the ETS Assembly
1. Ensure all debris is flushed from the piping system before installing the ETS assembly.
2. Place the ETS assembly in the desired location (refer to "Selecting a Location for the ETS Assembly" on
page 13).
3. Ensure the ETS assembly is level. Use shims (not provided) if necessary.
4. If required by local codes, secure the ETS assembly frame to the floor and/or wall:
a. Drill into the floor and/or wall through holes in the ETS assembly frame (Figure 7 and Figure 8).
b. Install the appropriate anchors (not provided) and secure the frame to the floor and/or wall.
NOTE: The assembly may be secured to the floor and/or the wall using the holes in the cross
members of the frame. Anchor bolts are supplied by others.
Figure 7: ETS Simplex – Floor Mounting Anchor Locations
059326‐00 Rev D
Heat‐Timer Corp.
Advertisement
Table of Contents
Need help?
Do you have a question about the ETS and is the answer not in the manual?
Questions and answers