Hot-Plug Hard Drive Guidelines - HPE ProLiant SL270s Gen8 User Manual

Install the DIMM.
11.
Install the processor air baffle.
12.
Install the GPU cage
13.
Install the SFF hot-plug drive cage.
14.
Install the shipping brackets and shipping plates.
15.
Install the server into the chassis
16.
Power up the server (on page 14).
17.
After installing the DIMMs, to configure memory protection mode, use RBSU
Utility" on page 78).

Hot-plug hard drive guidelines

When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest device number.
•
Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
WARNING: To reduce the risk of injury from electric shock, do not remove more than one drive
carrier at a time.
("Installing the server into the chassis" on page 23).
("HPE ROM-Based Setup
Hardware options installation 38