Texas Instruments TMS320C6000 Reference Manual page 3

About This Manual
This document assists you in meeting the design requirements of the
XDS510 emulator with respect to JTAG designs and discusses the XDS510
cable (manufacturing part number 2617698-0001). This cable is identified by
a label on the cable pod marked JTAG 3/5 V and supports both standard 3-volt
and 5-volt target system power inputs.
The term JTAG as used in this document refers to Texas Instruments scan-
based emulation, which is based on the IEEE 1149.1 standard.
Notational Conventions
This document uses the following conventions.
-
Related Documentation From Texas Instruments
The following documents describe the C6000 devices and related support
tools. Copies of these documents are available on the Internet at www.ti.com.
Tip: Enter the literature number in the search box provided at www.ti.com.
TMS320C6000 CPU and Instruction Set Reference Guide (literature
TMS320C6000 Peripherals Reference Guide (literature number SPRU190)
TMS320C6000 Technical Brief (literature number SPRU197) gives an
TMS320C64x Technical Overview (SPRU395) gives an introduction to the
SPRU641
Hexadecimal numbers are shown with the suffix h. For example, the
following number is 40 hexadecimal (decimal 64): 40h.
number SPRU189) describes the TMS320C6000 CPU architecture,
instruction set, pipeline, and interrupts for these digital signal processors.
describes the peripherals available on the TMS320C6000 DSPs.
introduction to the TMS320C62x and TMS320C67x DSPs, develop-
ment tools, and third-party support.
TMS320C64x DSP and discusses the application areas that are
enhanced by the TMS320C64x VelociTI.
Preface
Read This First
Designing for JTAG Emulation 27