Mechanical Dimensions For The 14-Pin Emulator Connector; Pod/Connector Dimensions - Texas Instruments TMS320C6000 Reference Manual

Dsp designing for jtag emulation

Hide thumbs Also See for TMS320C6000:

Table of Contents

Mechanical Dimensions for the 14-Pin Emulator Connector

The JTAG emulator target cable consists of a 3-foot section of jacketed cable,

an active cable pod, and a short section of jacketed cable that connects to the

target system. The overall cable length is approximately 3 feet 10 inches.

Figure 6 and Figure 7 show the mechanical dimensions for the target cable

pod and short cable. Note that the pin-to-pin spacing on the connector is

0.100 inches in both the X and Y planes. The cable pod box is nonconductive

plastic with four recessed metal screws.

Figure 6.

2.70

0.90

Emulator Cable Pod

Note:

All dimensions are in inches and are nominal dimensions, unless otherwise specified.

Designing for JTAG Emulation

4.50

9.50

Short, Jacketed Cable

Connector

Refer to Figure 7.

SPRU641

Table of Contents

Do you have a question about the TMS320C6000 and is the answer not in the manual?