Buzzer; Buzzer Loudness; Good Read Buzzer - Opticon L-46X User Manual

4.1

Buzzer

Buzzer operation settings are described below.
4.1.1

Buzzer Loudness

The buzzer loudness can be set with these options, which is applied to all buzzers.
Item
Buzzer loudness
4.1.2

Good Read Buzzer

The good read buzzer is activated when a code is successfully read and the data is output.
3 types of tone and 5 types of duration are configurable. The good read buzzer can also be disabled.
● Buzzer Disable/Enable
Item
Buzzer
Disable/Enable
● Buzzer duration
Item
Buzzer duration
● Buzzer tone
Item
Buzzer tone (*)
* The good read buzzer tone (frequency) can be set with numerical parameters by inputting the command
followed by a 4-digit numerical command.
Frequency range normally use is 2000 to 4000 Hz. The scanner most resonance around 2750 Hz.
Item
Buzzer tone
frequency
setting
L-46X User's Manual
1st
Command
T0 Buzzer loudness : Maximum
T1 Buzzer loudness : Loud
T2 Buzzer loudness : Normal
T3 Buzzer loudness : Minimum
Command
W0 Disable buzzer
W8 Enable buzzer
Command
W7 Buzzer duration: 50 ms
[EFW Buzzer duration: 75 ms
W4 Buzzer duration: 100 ms
W5 Buzzer duration: 200 ms
W6 Buzzer duration: 400 ms
Command
W1 Middle frequency buzzer (3000 Hz)
W2 2 steps buzzer (high - low buzzer)
W3 2 steps buzzer (low - high buzzer)
Command
[DF0 Qa Qb
Description
Description
Description
Description
Description
Numerical setting of
Qc Qd buzzer tone frequency
(1000a+100b+10c+d)[Hz]
Chapter-4
Indicator Options
Default

Default

Default

Default
2600 Hz
Default
2600 Hz
(1-9999)
28