Save Settings; Custom Setting; Various Interface Switching - Opticon L-46X User Manual

3.2.2

Save Settings

The Active Settings can be written into the "Startup Settings".
Item Command
Save settings
* Place "Z2" at the end of command packet to be saved.
* Saving settings for more than 30,000 times may destroy memory. Avoid saving every time.
* There are options that will not be enabled until "Save settings" is sent, such as baud rate setting.
3.2.3

Custom Setting

Item Command
Custom settings
* Place "[BAQ" at the end of command packet to be saved.
* To save both "Custom settings" and "Active Settings" at same time, send "[BAQZ2".
* Custom settings for more than 30,000 times may destroy memory. When setting frequently, avoid saving every
time.
3.2.4

Various Interface Switching

Various interface factory setting can be change. Cable changing is required for USB and RS-232C.
This setting is also saved when updating firmware.
Switch to USB-HID
Item
Change interface to
USB-HID
Switch to USB-COM
Item
Change interface to
USB-COM
Switch to RS-232C
Item
Change interface to
RS-232C
L-46X User's Manual
1st
Z2 Save the Active Settings as Startup Settings
[BAP Read out Custom Settings
[BAQ Save to Custom Settings
Command
[X.ZSU[X.ZZ2
Command
[X.Z[C01[X.ZZ2
Command
[X.ZU2[X.ZZ2
Description
Description
Menu
Menu
Menu
Chapter-3
Configurations
Remark
Command only
Remark
Remark
Confirm cable
Remark
Confirm cable
Remark
Confirm cable
24