8.2
Manual Trigger
8.2.1
Trigger Repeat
Trigger repeat helps the user to properly aim the scanner before it starts scanning. This can be very
handy in situations where several codes are printed close to each other.
The actual behavior depends on the configuration of Read Time. (See 8.1.3)
Item
Trigger repeat
The operation varies depend on the Read Cycle Timeout (refer 8.1.2).
● Read time option: When trigger key is synchronized (Default).
Example)
"While trigger is pressed"
● Read time option: When read time option is 1 second or more.
Example)
"While trigger is pressed"
L-46X User's Manual
1st
Command
/K
Disable trigger repeat
/M
Enable trigger repeat
"Release trigger"
"Start reading by pulling trigger again"
Description
Chapter-8
Read Options
Default
"Output data"
"Output data"
101