Buzzer And Indicator; Trigger Command; Direct Numerical Input Command - Opticon L-46X User Manual

3.3.5

Buzzer and Indicator

These commands reflect "4.1 Buzzer" and "4.2 Status LED".
Item
Buzzer
Status LED
3.3.6

Trigger Command

The reading operation can be started and terminated by sending commands. When the read cycle
timeout (refer to 8.1.2) is set to 0 seconds (Y0 command), the read time with the Z command will be
'Indefinitely' and reading will continue until a Y command is received.
Item
Trigger Command
3.3.7

Direct Numerical Input Command

When a command requires additional numerical input, the commands below can be used. Use these
in one packet together with the command that requires the numerical input.
Item
Direct input numerical
values
L-46X User's Manual
1st
Command
B Sound the good read beep
E Sound the error beep
L Flash the status LED
Command
Z Start the read cycle
Y Stop the read cycle
Command
Q0 0
Q1 1
Q2 2
Q3 3
Q4 4
Q5 5
Q6 6
Q7 7
Q8 8
Q9 9
Description
Description
Description
Chapter-3
Configurations
Remark
Command
only
Remark
Command
only
Remark
Input in a
specified
format
26