Opticon OPN 2001 User Manual
  1. Manuals
  2. Brands
  3. Opticon Manuals
  4. Scanner
  5. OPN 2001
  6. User manual

Opticon OPN 2001 User Manual

Pocket memory scanner
Hide thumbs Also See for OPN 2001:

Advertisement

Table of Contents

Users Manual
OPN 2001
Pocket Memory Scanner

Advertisement

Table of Contents
loading

Related Manuals for Opticon OPN 2001

Summary of Contents for Opticon OPN 2001

  • Page 1 Users Manual OPN 2001 Pocket Memory Scanner...
  • Page 2 Opticon product. Warranty / Warranty period / Liability Unless otherwise agreed in a contract, all Opticon products are warranted for a period of two years after purchase, covering defects in material and workmanship. Opticon will repair or, at its opinion, replace products that prove to be defective in material or workmanship under proper use during the warranty period.

  • Page 3: Table Of Contents

    Clear all data (Remove all items from memory) 3.3.2 Toggle buzzer ON/OFF 3.3.3 Reset to default Install the USB driver for Windows XP/2000 ........8 Connect the Scanner to the PC............8 Charging the battery..............10 Buzzer and LED indicators............10 OPN 2001 OPTICON - 3...

  • Page 4: Introduction

    USB port, which is also used to charge the internal battery. Unpacking The OPN 2001 is supplied with a hand strap and an USB cable. Detailed view Laser exit...

  • Page 5: Handling Instructions

    ! There are no user-serviceable parts inside the scanner. So do not try to take it apart. ! In case of serious malfunction, please consult your local dealer or Opticon. Recycling & Disposal instructions The icon on the product or package indicates that the product should not be thrown in the home waste bin.

  • Page 6: Getting Started

    (if there are more of these barcodes, they are not deleted). If the barcode was not found in memory, the scanner will issue a low error beep. OPTICON OPN 200...

  • Page 7: Special Functions

    Reset to default When both the Scan button and the Clear button are pressed and held pressed for at least 10 seconds, the scanner sets all configuration variables to factory default and clears all the data. OPN 2001 OPTICON - 7...

  • Page 8: Install The Usb Driver For Windows Xp/2000

    Please install the USB driver software before connecting the scanner to your You can obtain the USB driver for this product by downloading it from the support section of the Opticon website; alternatively contact your Opticon representative. Once downloaded, start the setup program. It then shows the...
  • Page 9 Keep the selection to “Install the software automatically” and click on the Next button. The software will be installed and when the following screen is shown, a click on the Finish button finalizes the installation: OPN 2001 OPTICON - 9...

  • Page 10: Charging The Battery

    The descriptions below are indicated when the product is connected to the PC. Red – Continuous: The battery is being charged. Green – Continuous: The battery is fully charged. Red / Green flashing: The battery may be defective. Return the scanner to the nearest Opticon service centre. OPTICON OPN 200...
  • Page 11 “Set all default” sequence has been performed. LOW, MEDIUM: The barcode is deleted from memory:. A long LOW: The barcode was not previously scanned, so it is NOT deleted. HIGH, LOW: The memory is FULL, the barcode is NOT added. OPN 2001 OPTICON - 11...

Table of Contents