Table of Contents
Advertisement
NLV-5201 Specifications Manual
20.2 Read, Trigger, and Buzzer Default Settings
Parameter
Read Mode
Read Effective Time
Buzzer Duration
Good Read Buzzer Tone
Start-Up Buzzer
Buzzer Loudness
Buzzer Timing
Good Read Indicator Color
Good Read LED Indicator Duration
Data Buffering*
*
Data buffering transfers the next piece of data that is read during the read data transfering process. Depending on
the host system, output data may be lost.
20.3 Interface Communication Default Settings
20.3.1 RS-232C Default Settings
Parameter
Baud Rate
Parity Bits
Data Bits
Stop Bits
Handshaking
ACK/NAK
CTS Time Out
ACK/NAK Time Out
Command Header
Command Terminator
Response to Commands
20.3.2 USB Default Settings
Parameter
Keyboard Language
Send "new line key "after data
Send "TAB key" after data
Send "→ key" after data
Other
*
To use USB-COM, you need to install the latest version of the Opticon USB-COM driver on your host device.
46
Default Setting
Single read
Trigger synchronized
100 ms
3000 Hz
Enable
Maximum
Before data transmission
Green
200 ms
Buffered mode
Default Setting
9600 bps
No parity
8 bits
1 bit
No handshake
Disabled
Indefinitely
1 second
ESC or STX
CR or ETX
Disabled
Default Setting
USA (USB-HID)
Enabled
Disabled
Disabled
CDC-ACM compliant (USB-COM)*
Advertisement
Table of Contents
