Positive & Negative Bar Codes; Setting The Trigger & Auto-Trigger Functions - Opticon LMD 1135 User Manual

Manual No. 25-ULPNR102-01; Mar, 2005
26. Positive & Negative Bar Codes
Computer
Command
(ZZ)
V2
V3
V4
27. Setting the Trigger & Auto-Trigger Functions
Computer
Command
(ZZ)
S7
S8
+F
+I
Z
The Trigger function is enabled in the default setting. This means that the laser is "OFF" until triggered
by command or via the Auto-Trigger which is also enabled in the default setting. For some applications,
you may wish the laser to operate continuously, although this is not recommended. This can be done by
disabling the Trigger function using the S7 command. Once in the "Trigger Disabled" mode, the laser is
on continuously.
The software trigger is actuated by downloading and <ESC> Z <CR> computer command from the host.
(See Scanner Timeout to establish the length of time the scanning light remains ON after the trigger is
activated.) A hardware trigger is not available with this scanner.
Function
/Description
START/END
Programming Menu
Positive bar code only
(black bars/white spaces)
Negative bar codes
Both positive & negative bar
code
Function
/Description
START/END
Programming Menu
Disable the trigger function
/ laser is ON continuously
Enable the trigger function /laser
is OFF until trigger is activated or
"pulled"
Disable Auto-trigger
Enable Auto-trigger
Activate the trigger; turns on the
laser
LMD 1135 Laser Fixed Mount Scanner
Bar Code
Command
[[
W3
W!
W5
Bar Code
Command
[[
T8
T9
,G
,J
Use as
Computer Command
Page 58