Table of Contents
Advertisement
5.3. ADVANCED SETTINGS
5 SETTINGS
4.6.2.
TROUBLESHOOTING
The TROUBLESHOOTING option is available only when the PC is communicating with a relay. It is intended to
check the ModBus communication frames between the PC and the relay. In the upper part, the user can read any
2
readable value from the relay (setpoints, actual values) by entering the desired hexadecimal address
, the type of
data to read (Setpoints, Actual Values), the number of registers (the length of each register is of 2 bytes) and the
format of the data (integer, long, float...), checking the checkbox at the left to make the PC start polling that address
or unchecking it to stop.
In the lower part, data can be sent to writeable addresses of the relay. The working is similar to reading but, to send
the data, the user must press the SEND button.
FIGURE 4-24. TROUBLESHOOTING
Refer to preceding section to learn about Print Screen button.
2
To check how to read memory map addresses from the relay refer to the corresponding section further in this chapter
4-20
MIF Digital Feeder Protection
GEK-106273L
Advertisement
Table of Contents
