GE GEK-106273L Instruction Manual page 202

NAME
Events
Active table
Frequency
Alarm
Output 1
Output 2
Output 3
Output 4
Input 1
Input 2
Ready
Trip LED
LED 1
LED 2
LED 3
LED 4
Logic 1
Logic 2
Logic 3
Logic 4
Table change
Settings change
disabled
Cold load pickup
Breaker 52a
Breaker 52b
Breaker status
Breaker failure
Counter
Number of openings
I2 Alarm
Local/remote
GEK-106273L
ANNEX 6 STATUS LIST
DESCRIPTION
settings group)
Number of events produced since the last time they
were deleted
Shows which table is active (table 1 or table 2)
Frequency value entered in the "Frequency" setting
(general settings group)
Alarm contact status. This contact is enabled when
"Protection" is out of service, or when all trips are
disabled (either by setting or by digital input).
Status of Auxiliary Output 1
Status of Auxiliary Output 2
Status of Auxiliary Output 3
Status of Auxiliary Output 4
Status of Digital Input 1
Status of Digital Input 2
Status of the READY LED. Same as for the alarm
contact.
TRIP LED status
LED 1 status
LED 2 status
LED 3 status
LED 4 status
Output status of logic 1
Output status of logic 2
Output status of logic 3
Output status of logic 4
Shows whether the Table 2 selection by digital input
is active. If so, Table 2 is shown; if not, the set table is
activated.
Shows whether the Settings Change is inhibited by
digital input. If so, it is not possible to change settings
or command operations from the PC or the MMI. The
table change is permitted by digital input.
Shows whether the cold load pickup is activated.
Status of the breaker terminal A.
Status of the breaker terminal B
Breaker status
Indicates a breaker failure
2
Value of the I counter
Number of openings
2
Active when I counter value exceeds the counter
maximum limit, set in the BREAKER FAILURE TO
OPEN group of settings.
Active when the MMI is on the settings or operations
MIF Digital Feeder Protection
OPTION OPTION OPTION
0 1 2
16-3