Installing The Unit - ElectrIQ eiQ60PBSLIMEN User Manual

INSTALLATION
•
Draw a vertical line up to the ceiling or up to the upper limit, at the centre of the area in
which the hood is to be fitted.
•
A horizontal line A at 790– 890 mm above the cooker top.
•
A horizontal line B at a X mm above the horizontal line A.
•
A horizontal line C at a 115mm below the horizontal line A.
•
Mark a point (1) on the horizontal line A, 80 mm to the vertical reference line.
•
Repeat this operation on the other side, checking that the two marks are levelled.
•
Mark a point (2) on the horizontal line B, 60 mm to the vertical reference line.
•
Repeat this operation on the other side, checking that the two marks are on the same
horizontal line.
•
Mark a point (3) on the horizontal line C, 150 mm to the vertical reference line. Repeat this
operation on the other side, checking that the two marks are levelled.
FIX THE BRACKETS
•
Drill holes at the marked points with a ɸ10 mm drill bit.
•
Insert the Wall Plugs 11 into the holes.
•
Fix a Chimney fixing bracket 21 with 2 screws 10 (5 x 50) at the
horizontal line B.
horizontal line A; approximately the four fifth length of the screws 10
(5 x 50) was screwed into the Wall Plugs 11, used for hook the
hood.
LOWER DECORATIVE CHIMNEY
•
Fix the exhaust pipe on the hood body, connect chimney and hood body with 2 screws 12.
connect chimney fixing bracket and chimney with 2 screws 12.
Screw 2 screws 10 (5 x 50) to Wall Plugs 11 at the
9