Table of Contents
Advertisement
3.2 Flow Chart for Slave Configuration
After getting the DeviceNet I/O information of the slave devices by the
APIs or the utility tool, the information needs be saved into the EEPROM of the
I-8124W. The users could follow the flow chart to save the parameters into the
EEPROM of the I-8124W module. The firmware in the I-8124W module will
load the previous configuration from the EEPROM in the next boot-up. When
the arrangement of the devices in the DeviceNet network is changed, users
must reconfigure to fit the application. The configuration flow chart is shown in
Figure 3.3. More information about these functions is presented in the next
chapter.
I-8124W DeviceNet Master API functions User's Manual (V 1.6)
Figure 3.3 Slave Configuration Flow Chart
2021/10/04
32
Advertisement
Table of Contents
