Configuration Of Dvpdnet-Sl; Configuration Through Devicenet Builder Software; Selection Of Communication Channel - Delta DVPDNET-SL Operation Manual

DeviceNet Network Scanner DVPDNET-SL

4 Configuration of DVPDNET-SL

4.1

Configuration through DeviceNet Builder Software

Before DVPDNET-SL starts to work, it must be configured through DeviceNet Builder software.
Note:
Different PLC corresponds to different device addresses. For details, please refer to Input and Output
Mapping Areas in Section 4.2. We take DVP-SV as the PLC for description below.
4.1.1

Selection of Communication Channel

Max 8 DVPDNET-SL modules can be connected to the left side of the PLC and every DVPDNET-SL is a
communication channel. When there are three DVPDNET-SL modules connected to PLC's left side and
DeviceNet Builder software is online, the following dialog box will pop up for selecting the current channel.
Parameter
Unit No.
Name
Code
Input
mapping
Output
mapping
8
The unit No. of the first DVPDNET-SL (DNET Scanner) on the left side of PLC is 1.
PLC's left side can be connected with max 8 DVPDNET_SL. The further
DVPDNET-S is from the PLC, the larger its unit No is.
DVPDNET-SL's name in DeviceNet Builder software.
For displaying the current mode of DVPDNET-SL: master mode or slave mode.
The register areas which PLC MPU distributes to DVPDNET-SL. The areas are
mainly used to receive the message from DeviceNet Slaves and the data from
slaves on the bus will be automatically updated to these registers.
The register areas which the PLC has assigned to DVPDNET-SL. The areas are
mainly used to control DeviceNet slave and the control data in these registers will
be automatically sent to DeviceNet slave in the bus. Slave will take some action
accordingly after receiving the data.
Explanation
DVP-PLC Operation Manual