Application Example; How To Construct A Devicenet Network - Delta DVPDNET-SL Operation Manual

DeviceNet Network Scanner DVPDNET-SL

10 Application Example

This section provides an example on how to construct and configure the DeviceNet network.
Control requirement
Note:
Different PLC corresponds to different device addresses. For details, please refer to Input and Output
Mapping Areas in Section 4.2. We take DVP-SV as the PLC for description below.

10.1 How to Construct a DeviceNet Network

1) Connection Figure
Note:
Delta DeviceNet remote IO communication module, RTU-DNET supports the MODBUS communication
function.
2) Set up DVPDNET-SL, RTU-DNET and
DeviceNet Module
DVPDNET-SL
32
Using X points of DVP28SV to control RUN/STOP of the remote AC motor drive VFD-L.
DeviceNet
VFD -L
V FD-L
RTU-DNET
DVPDNET-SL
DVP28SV
X0
START
X1
STOP
RS232
RS485
VFD-L
according to the table below.
Node address
01
02
D eviceNet Builder
RTU-DNET
Baud rate
500kbps
500kbps
DVP-PLC Operation Manual